About this 3D model

Hi folks! A Halloween Ice Cream pint holder was a must and nothing wins a good old Jack-O-Lantern ? It is multi-part - no need for AMS, CFS, or any other multi-color system. The holder has been tested with Ben & Jerry’s and Haagen-Dazs pints, but you may need to rescale it for your preferred brand. To help with that I included a Size_Tester.stl—print it first to check the fit. If it’s off, just scale all parts accordingly. Features include: Storage for two spoons on the back (Slightly larger than previous versions)A hole at the bottom to help push the pint up when you’re doneSwappable inserts to change the color of eyes, nose and mouthPrinting & Assembly Notes: All parts (except inserts) require supports - use organic/tree supports for best results. The spoon has a very small surface area - make sure your supports hold tit firmly. Push the handle against the cup (You should use some glue to enforce it) The hollow version has a larger hole at the bottom to accommodate a tealight, So when you are done using it as an ice cream holder you can use it as decoration :) There are 2 inserts - one can be printed with 2 walls as is, The other one is for Vase mode which will also provide you color transparency when used with a tealight. Tip 1: Using the inserts will create a slightly tighter area inside the cup - If the previous sizes worked perfectly for you you can increase the size of all parts by 1%-2% to make a bit more room Tip 2: If you want the insert without the bottom area - Just push those first layers below the print bed, you'll probably want to use a brim in that case. My print settings: Cup - 2 walls, tree supports 10% infill Handle - 3 walls, 15% infill, tree supports