About this 3D model

Update 12/07/25: Reduced screw hole size on "top" parts (now v2) to 2.79mm for extra screw grip. Here are ten cases in two halves, top and bot(tom). All based on the same blank template case which is called blk_top & blk_bot. That case is here for you to make your own design; don't print that as is, because it lacks ventilation. So I guess nine cases and one to make your own. Majority of the designs have vents in the bottom which are a bit pointless unless you stick on rubber feet. I use the little circles left over from those sticky rubber corners you get with some fans. Because they are all derived from the same case, you can mix and match the parts so for example you could use the sde_ bot part that provides ventilation without needing feet, with any of the top designs. Now you can have your Pi... and eat it? MY PATREON & PATREON SHOP. https://www.patreon.com/3DFreeman Thanks for all your continued support!