About this 3D model

[2025] This design is outdated for a number of reasons. The OpenSCAD source contains deprecated code, and the resulting STLs have alignment issues that were no issue on +0.4mm layer thickness, but may cause problems on todays quality printers.The same goes for the version w ventilation [https://www.thingiverse.com/thing:10926]. Feel free to update the source file yourself.[/2025]A case for the http://reprap.org/wiki/RAMPS1.3 board. Used here to drive a small milling machine with pyCAM/FiveD/ReplicatorG toolpath. It is a tight fit that does not leave much room for ventilation so take care that the drivers do not run too hot.