About this 3D model

Plenty of space for the Doctor! When the TARDIS is lifted a light and sound chip activates and plays the theme song. PHASE ONE: Designed and printed the model. PHASE TWO: I already had a SOMO-14D for another project and discovered it would fit in the Tardis. After scavenging a few additional components the Tardis has a blinking top light and theme song. The sound chip has a micro SD slot, a 2GB chip provides plenty of space for the current Dr. Who theme (200K). Build time was about two hours and included the following: 1 - [SOMO-14D Sound Module](http://www.4dsystems.com.au/product/10/117/Development/SOMO_14D/) 2 - [4001 Diodes](http://www.goldmine-elec-products.com/prodinfo.asp?number=G1301) 1 - [Sub-microswitch](http://www.goldmine-elec-products.com/prodinfo.asp?number=G16909) 1 - 680 ohm resistor 2 - [100uF 10v capacitors](http://www.goldmine-elec-products.com/prodinfo.asp?number=G9089) 1 - [78L05 regulator](http://www.goldmine-elec-products.com/prodinfo.asp?number=G13018) 1 - [Blinking white LED](http://www.goldmine-elec-products.com/prodinfo.asp?number=G18966) 1 - Scavenged 1" diameter speaker 1 - [9v battery clip](http://www.goldmine-elec-products.com/prodinfo.asp?number=G19699) So, my 50 cent TARDIS has turned into a $25 electronic geek toy, not counting the SD card. Oh well, finished it in time for the birthday girl. PHASE THREE: Printed the placard and signs for the top on a laser printer at 1200dpi. Attached them to the print with double sided tape. Uploaded a little video of it to [YouTube](http://www.youtube.com/watch?v=7d5P9jlaMI0). Enjoy! Wiring diagram added 12-20-2013. Parts list updated 12-23-2013.