About this 3D model

MangoT21's Beefed Up Replicator Extruder Bracket is quite nice. On his Replicator 1, he found that he needed to move the filament guide holes backwards 0.1 inches; whereas, on my Replicator 1, I found that the original guide holes were correctly centered for my extruders. Consequently, the holes on MangoT21's bracket were a bit too far back for my Replicator 1. This derivative is therefore MBI's original Wire-Filament Extruder Guide.SLDPRT model with the filament guide holes unmoved but reduced to a diameter of 9.5mm. Then the result exported from SolidWorks as an STL.