About this 3D model

This OpenSCAD script prints a WIMU holder for the WIMU defined in 2011-08-16_Alex_WIMUv3_tyndall_generic_device_packaging_v1.3.scadThe file is parametric and allows you to choose all relevant variables:Length, breadth, corner radius and fit tolerance of device to be held.Width, thickness and tolerance or belt/strap used. Holder height, thickness, separation between locations & desired loop hole axis/axes.Several .stl versions are given below with loops on the short, long and both axesVersion:0.8.4Date:2012-02-23Note:you will need the mouse_ears_test.scad file in the same folder for the mouse ears to compile with the version 0.4 and above .scad file properlyYou will need "WIMUv3_v1.5_2011-11-28_tyndall_generic_device_packaging_v1.4stacked.st" in the same folder for the ghost of the held WIMU package to appear correctlyDimensions beyond version 0.4 file have been changed to match the most recent version of the packaging found here http://www.thingiverse.com/thing:14298 i.e. 30.6x32.5x38.5mmChanges from previous versions:v0.8.4added locating arms to help attach top and bottom halvesfixed position of base of cap to allow it to be printedleft covers over cutouts to help with printabilityreduced print volume of cap using 3d cross shaped differencefixed tiny elevation error for capv0.8.3added capv0.8.2adjusted tolerances to get better fitinternal cutout size now correctly defined using twice the tolerance valuev0.8.1fixed code so that north and south cutout locations were swapped to make senseresized east hole to fit switch and moved southvariant for Kieran with strap holes on both axes, 28*3mm, holes for USB and switch, total height 16mmadded WIMU packaging ghost via .stl import to check location of cutoutsv0.8added ability to make cutouts in walls around held objectsAdded cutout for access to uUSB port on Tyndall WIMUv3 deviceCleaned up code a bitv0.7.1Variant made for Damien with loops on both Axes and low profilev0.7reduced tolerance on corners from 0.45-0.1v0.6increased tolerance from 0.3-0.45v0.5changed held item dimensions to take account of manufacturing and assembly tolerance i.e. 31.04 32.7 38.66increased tolerance from 0.2 - 0.3v0.4added mouse earschanged held item dimensions to those of mass produced SLA clear resin WIMUv3 Packaging i.e. 30.6 32.5 38.5Began process of fixing up/replaceing old rounded cuboid methodv0.3added ability to turn on or off loops on long or short axis and automatically adjust ext_l_holder & ext_b_holder in responseremoved the long axis loop holesdecreased loop holes size from 30mm->1" wide beltv0.2changed belt thickness 2->3added loop holes on short axisv 0.1First attempt