About this 3D model

In my office we have groups of 4 desks seperated with a fabric covered partition. A collegue of mine has these clips that have spikes in the back that go through the fabric as you can't use drawing pins (I assume under the fabric is MDF).This is my take on that clip. I have yet to print it so don't know if it will work. The official one was made of two parts which have a spring to keep the jaw closed. I replaced that on this on with some plastic that I hope has enough flex in to work, it may need to be made thinner, currently it is 2mm thick.-edit- Updated my apparently terrible typos!Update 1This doesn't work, the plastic PLA is too brittle to act as a spring in this format. I am currently working on a replacment design that may work.Please DO NOT print this, it won't work :(