About this 3D model

Decided to jump in on the Resistor Guide front. Although I'm not going to rule out (no pun intended, I swear) the possibility of metric/english errors in lead length, if I've done my numbers and fiddling right, these should land on tenth-of-an-inch spacing. Further Note: A shortened version has been added for easier printing on the CupCake. This version is only 8cm long. Note: Skeinforge didn't like the first version of this because the Array Modifier in Blender left behind about a hundred stray internal edges! I corrected this by manually deleting them (not *quite* as tedious as it sounds but close) but in future I'm going to be on the lookout for a better way to manifold-ize objects that have been array-ified this way...