About this 3D model

I built this quick as a way to protect my filament from the moisture in the air while it is attached to the printer. Things you need: A container that will hold a spool of filament ~ I got mine at Real Canadian Super Store 3 for $8 Screws ~ I used #6x1/2 but shorter screws would be better 5/16" inside 3/4" outside rubber washers ~ Home Depot A seal for the filament ~ I used a single "Fun Foam" bead from Walmart $2 for a bag full When drilling place a piece of wood behind the container so it does not break. You will see that there is a larger gasket holder, use that to cover any cracks that may happen. I drilled all the screw holes in the container over sized so the plastic would not break and drilled all other holes at 1/2".