About this 3D model

STL revised so that NO SUPPORTS need be added. A hanging holder for one or two standard 60mm suet balls. Print both container and hanger. Any PLA filament will be fine. Birds love suet - especially if easy to get and high off the ground. I started out with a couple of versions of store-bought suet feeders. This gave me ideas for what NOT to make. The feeder had to be good looking, easy to maintain, and bird friendly. All design done with Tinkercad. First version had holes that were too small for birds to put their heads through. The second version worked well but was weak with thin walls between holes and soon fell apart. The third version had holes that were too big and suet fell out when down to the size of golf balls. Also the walls were too slippery and the birds could not reach the middle position. This version that I am now publishing solves all the problems. The extra perches allow birds to reach all parts of the feeder and the holes are big enough for birds to reach inside but still small enough to prevent suet from falling out until the final crumbs.