About this 3D model

This is my enclosure for the Power supplyIt fits on a 360 Watts power supply with a size of 112 x 52 x (any length my has 210) mm.There is a hole for a standard switch and power plug.I printed it in ABS clear with honeycomb infill.There are NO mountings for the illumination LEDs, just soldered 3 and a 120 Ohm resistor to a stripe and plugged them to the 12V line.Be careful with the mains voltage its very dangerous I guarantee for nothing.fits withhttp://www.thingiverse.com/thing:338502For more information about the printer visit my build blog:http://chaozlabs.blogspot.de/2014/05/building-my-delta-printer.html