About this 3D model

Carl's Aluminum X-Ends (shop.raffle.ch) are a great upgrade for Replicator 2's and 2X's. The installation instructions suggest the use of tie-wraps to route the X-axis wire harness. I wanted something a little better. This cable race is designed for use with the Cicoil full-motion cable upgrade that I have installed on my machine. I think this may be of use for those using the standard harness, I do not know. It might need slight modification or the clever use of tie-wraps. I am using M3x6mm screws, but any reasonable length M3 screws will probably work of approximately the same size. This is not as elegant as my stock X-end cable harness strain relief, but gets the job done for me. Your mileage may vary.