About this 3D model

Smaller print bed, slightly wider, and angled isolator holes. This uses the Hovership MHQ arms. Current setup: 4- Sunnysky x2208 2600kv 4- 20A Slim Afro ESC 1- MultiWii Pro EZ3.0 1- BT module 1- Frsky v8fr-ii HV 8- 37mm standoffs (will be changed to 1.5" later) 4- HQ 5030 props 1-Turnigy Nanotech 3300mah 3S LiPO VTX/Camera/MinimOSD this weekend 890g AUW Update V 0.3 -CAUTION If you fly with a heavy battery on the top plate and you go into an auto-level mode your moment of inertia delta between your clean and dirty plate will result in an unstable system and you will crash. I learned this the hard way...nothing broke though! -FIXED All hardware holes are slightly larger for easier assembly -FIXED Protruded the vibe isolation settings to give better print quality. -NEW 45x45 FC can now be suspended from top plate. -NEW Battery can be suspended from bottom plate as well as set on top plate. -NEW Added landing gear -NEW FC Plate extended to give more real-estate to mount stuff -NEW Integrated top plate and cam holder. Also, added a VTX mount on rear. Update V 0.2 -FIXED Standoffs prevented mounting of Naze32 -FIXED Power Distro Board was too snug (make a little wider) -FIXED Reduced number of holes on Bat Plate -NEW Camera Holder Update V 0.1 -NEW FC Plate -NEW Batt Plate