About this 3D model

DAGOMERLIN Ring holder bulb to make your wedding rings shine At first, my first model was just a simple bar on a base, but after some thought, I decided that it wasn't practical to have to remove the first rings to take the last one. So I set out to find a system that could support several rings. The spring was the most obvious solution, but not the easiest to model. I found that my model strongly resembled a light bulb if you imagined the base and the glass. there are 3 parts that are easy to assemble and glue (with hot glue, for example): -spring: 1h printing time (I strongly advise you to position the part as I did if you have Cura by dagoma) -base: 2h printing time -glass: 15 min printing time