About this 3D model

There are many printable Eggbot-Derivates outside, but after building one, I noticed that the Software-Toolchain for Eggbot-like devices, based on Arduino-Platform, without the original EBB-Electronics is very complicated and not userfriendly. So I decided to create a new firmware, which simulates the original Eggbot (EBB)- Serial Protocol. I will not talk much about hardware, because here in Thinkiverse are lots of people, who have created a good 3D-printable basis. This thing gives you the ability to fill them with life. (Software) This is fully functional, but I marked it as "Work in Progress", because there could be some minor tweaks done....