About this 3D model

Rear lens cap for Arri S (Standard) lenses. A couple of versions included, 25mm deep for lenses that don't protrude beyond the back of the mount (mostly 35mm lenses) and one 40mm deep for 16mm lenses. With Arri logo or plain.. With logo, v4 is recommended, v1/v2 are tight but may be suitable if printed in flexible material. v5 is a plain rear cap, but thicker side-wall (1.6mm), and for me in FDM/0.2mm layer is the strongest and best fit in PLA. Arri B (Bayonet) lens cap: Again, a couple of versions. The single part (v4) may awkward to print with FDM printers (because it needs internal supports). So a piece with a separate top, that can be glued or melted on, is included. (It should also be possible to print the open shell and one of the "cap" versions together as one piece, eg in Cura). Arri-B lens cap rear v4 is the version recommended.