About this 3D model

Printable vent screw for stand up paddleboards*. It probably needs some o-ring grease* to get a watertight seal. I printed it at 100% infill. These don't have any cuts perpendicular to the threads, so they probably wont vent as rapidly as some of the others when partially loosened. I made these so I don't have to use surf wax next time I misplace my vent plugs. I think there are a few different thread styles so I'm not sure which boards this design will fit. This design has a 1.5mm pitch and threads are approximately 12mm in diameter. The slot is sized to be tightened using a quarter. I also added a threaded vent plug holder, made for attaching to a leash. Printer: -- Eustathios Filaments: (full list can be found on thrinter) -- eSun Red ABS -- Sainsmart Transparent Red TPU -- NinjaFlex Fire TPE *affiliate link *Exclusive sponsored gift by @Wesup included with this design.