About this 3D model

Despit being an enclosed deisgn , these printers still hvae holes, crevaces and gaps where VOCs can leak into the immediate environment. Create negative pressure to extract VOCs continuously out a window or through a filter. This kit includes: a bracket for the X1C, P1S or P1P with housing 92mm fan housing vent Use 4 inch ducts to connect all the components. Fan Housing This is a basic housing for a 92mm computer fan. There are 4mm diameter holes on each side to hold the lid in place and an exit hole for the fan wiring. Attach a 4inch duct to each side. 4-inch Duct Bracket A simple bracket to attach a 4-inch duct to the back of an X1, X1C, P1S, and P1 with corresponding housing. Attach with magnets for easy installation and removal or VHB tape for a better seal. Window Vent This is simple vent/intake meant to be used in a window without the need to drill through a wall, thus the minimal clearance. Use this with a thin sheet of plexiglass, cardboard, or any other similar material. Add mosquito screen/mesh to keep bugs and pests out.