About this 3D model

Hey folks! Printing rules are the same for this one as the original by Tommy Williamson . I also added a file for TPU feet. You will want to add this so the Stock D-pad is not interfering or you can use any other standard rubber feet. I resized mine to about 14mm in height and placed them over the top panel screws and rested the bottom ones underneath those where the lockdown bar meets the top panel. I then applied adhesive to the feet and placed the SwitchPin on the feet carefully lining the edge. Now the feet act as extra lateral support during play. If you do not have top panel screws (newest units do not) then you will just want to place your feet so that they are level and free of obstruction. Bonus haptic feedback transfer if feet are placed near stock exciter location!