About this 3D model

Zeus and the Giants This was printed with a 0.2 nozzle, which produces 0.04mm layers a little nicer. It is possible with a 0.4 nozzle, though you will need to have calibrated your printer and filaments very carefully. You can however, still print this with a 0.4 nozzle and change the layer height of the stl to 0.08mm, by just adjusting the .hfp file in Hueforge that can be downloaded here . Alternatively, you can also do some math and use half the layer height (if it tells you to swap at layer 24, you'll want to swap at layer 12). Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm Filaments Used: PLA Siddament Black Transmission Distance: 0.2 PLA+ Sunlu Coffee Transmission Distance: 3 PLA Sunlu Beige Transmission Distance: 8.2 PLA META Sunlu White Transmission Distance: 9.6 Swap Instructions: Start with Black At layer #24 (1.08mm) swap to Coffee At layer #28 (1.24mm) swap to Beige At layer #43 (1.84mm) swap to White for the rest. Your filament settings and mine may differ in TD, so best to adjust yours according to your known TD filaments.