About this 3D model

This model utilises two white filaments of different TDs to achieve the smooth transitions you see in the image attached. I used both a low TDF and high TD white for this, so for best results, you should use something similar too! Print Instructions Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm Filaments Used: - PLA Kingroon Black Transmission Distance: 0.4 - PLA+ eSun Grey Transmission Distance: 1.4 - PLA Sunlu Beige Transmission Distance: 8.2 - PLA Kingroon White Transmission Distance: 8 - PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions: - Start with Black - At layer #19 (0.92mm) swap to Grey - At layer #22 (1.04mm) swap to Beige - At layer #32 (1.44mm) swap to White - At layer #39 (1.72mm) swap to Jade White for the rest.