About this 3D model

Summary I had to make this because the v2.0 Bumblebee and Green Hornet ducts are 2 mm wider and 1mm taller compared to the v1.3 ducts that are readily available here on Thingverse. Print Settings Printer Brand: FlashForge Printer: Creator Pro Rafts: Yes Supports: No Infill: 100% Notes: Print upside down (with the notches up) and it won't need supports. All 3 notches are the same size (the OEM ones have one notch that's deeper than the other 2). I've found that using a raft keeps it from being knocked off the print bed. How I Designed This This also was my first build using Fusion 360 instead of Tinkercad. I'm very much still learning which is why all 3 notches are the same size, I did manage to figure out how to make the duct roughly shaped the same as the OEM one: narrower at the top and wider at the bottom. Dunno if that serves an actual purpose or not =)