About this 3D model

Decided to roughly remake an image acquisition spinning disc I am using in one of my classes. The disc is 20cm (8 inch) in diameter For balancing the disc it is important to print the disc at 100% infill. Glue the disk details onto the disc, I used Super glue/ instant glue. What you'll need: Printed: 1 x Disc 1 x Stand 2 x Bearing screw spacer 1 x Large Section 1 x Small circle 2 x Arrow 4 x Quarter dividers Non-printed: 1 x M6x30mm screw, flat head with 10mm wide head 1 x M6 Nut or Nyloc nut 2 x 608 Bearing (skateboard/ roller skate bearing)