About this 3D model

minor update and a few modifications to my bed wire management clamp (works best with 3/8" automotive wire loom) Mostly just added an angle upward slightly for more even flex and made the mount wrap around the loom instead of inside to give wires more room. Mounting/screw hole isn't in the design, I've found there is just too many different printers with too many different plates and too many different wiring run preferances to make one for them all. easy is to hold in preferd location for your printer, use a lighter and just mildly heat up the end of the screw and push it through the plastic. then install . :)