About this 3D model

Summary Some additional wall control brackets to go with the amazing DDD Printable Wall Control project. The hex bit holder is a remix of https://www.thingiverse.com/thing:1692958 however, thingiverse wont let me add an additional source I like to print the sidepieces in PETG due to the wall control attachment point being quite thin. Dont forget the back pieces as it adds some rigidity. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.28 Infill: 10% Filament: Eryone PLA Matte Green Notes: Tool holders are PLA, side pieces are PETG. The attachment slots on the side pieces might take a little clean up as they are snap to fit but are quite tight. I had to take a razor blade and taper the edges a little. Don't forget the back pieces as it adds some rigidity.