About this 3D model

Summary This is a 3D-printable motor pulley to replace the stock one on a Dreaming Robots Electric Eel Wheel Nano. It'll work with either the v1.0 or v1.1 motor, and you may need a drop of CA glue to secure it to the motor shaft. This is the pulley that I sell on my website. Print Settings Printer Brand: LulzBot Printer: TAZ 4 Rafts: No Supports: Yes Resolution: 0.1mm Infill: 35% Filament: Any PLA Notes: I have my supports as follows (S3D settings, but can be adapted to other slicers): Support Infill Percentage: 20 Extra Inflation Distance: 1.6mm Support Base Layers: 1 (doesn't matter) Combine Support Every: 2 layers Max Overhang Angle: 55° Horizontal Offset: 0.55mm Upper Vertical Separation Layers: 1 (or 0.1mm) Lower Vertical Separation Layers: 2 (or 0.2mm) Dense Support Layers: 5 Dense Infill Percentage: 90 Support Infill Angles: 0 Post-Printing Afte printing, remove supports with pliers. You should be able to grab the supports sticking out the side and pull them out. Go around the pulley with a sharp tool to scrape out any remnants inside the groove.