About this 3D model

This is a simple conversion kit for the dbot. With this adapter and some screws you can upgrade your printer to mgn12h linear rails. By doing so there will be no wobble in the hotend. Y-carriages seems fine without double rails. I would recommend you use two rails on the x-axis(H-bar) Bill of materials per linear railsThis means if you want rails on both top and bottom you need to multiply this by two. Important! - You need to trim the H bar 5mm 4x m5x12 (two on front and two on back)4x M5 washers4x m3x8mm to fasten carriage to mgn12 carriage4x m3 washers