About this 3D model

These are compatible parts for the cylinder supplied with the Dynaseal Rain Drain, which is at least sold in America under Dynaseal Rain Drain branding and the Nordics and UK via RainDrain branding. They were created as the original cylinders and caps degrade more rapidly than the plastic tubing. All four of my original cylinders expired three times quicker than the tubing. These parts are compatible with the originals and vice versa, hence if you just need a cap, just print a cap etc. There are two variants of the cylinder, one of which (upgrade version) only requires one cap and the other is open at both ends like the original. Holes have been included not just for removal, but also to thread through the ties. Printing As this is push-fit like the original it may be sensitive to small changes in tolerances. Your printer is in a different environment, with different plastics and settings. If this results in a poor fit with original parts consider printing all the replacements and using them instead. These parts are made to print directly on the print bed with no supports. The cylinder should be printed vertically. I used an outer brim for the cylinders, as tall thin parts have a habit of falling over otherwise. Note that the cylinder is 22cm high.