About this 3D model

This is a bike chain. fidget toy, based on Pdb6251's “brock split ring” model. Note that the split ring contains an upper and lower ring segment, separated by a 0.2mm gap. This will appear as a floating segment when sliced – but it prints fine (albeit slightly fused). Assembly instructions: Split the rings using a small flat screwdriver or dill knife, as pictured. They should separate easily once started, as the layers are not well adhered. Link the split rings like a chain. Attach one figure 8 segment to each split ring, forming a linger chain: figure-8, ring, ring, figure-8 Attach the open hole of one figure-8 segment to the opposing ring (step 4 in the figure) Attach the open hold of the remaining figure-8 right to the opposing ring (step 5 in the figure)