About this 3D model

This is a holster for the Leatherman Wave+ multi tool. I made it as two separate pieces so that each piece can be printed in the correct orientation to optimize for strength. Many of the other existing models are too weak and break easily because of where the layer lines are, and/or they require a lot of support. If something unfortunately DOES break with this one, you also have the added advantage of only having to reprint the clip OR the holster, rather than the whole thing. The two pieces should slide together, and a couple of clips keep them from coming apart. Print instructions Printer: Anycubic i3 Mega-S Rafts: Doesn't Matter Supports: Yes (clip only) Resolution: 0.15 Infill: 20% Cubic Subdivision Filament: Filaments.ca EconoFil PLA (Black) Notes: Print the two pieces as they have been positioned in the STLs. Do not rotate them. I printed mine at a .15 layer height, and it turned out really nicely. The supports can be pretty difficult to remove around the two clips. If you have trouble, try using a razor knife to separate things. I suspect it would probably also print okay at 0.2, but I didn't have great luck with the one I tried to print at 0.3. When printing the clip, You MUST change the support overhang angle in Cura to 50 degrees for the supports to be generated correctly!* If this design was useful to you, please post a make!