About this 3D model

I was hacking a Halloween decoration and needed a way to mount a TinyS3 as double sided tape wasn't cutting it. Insert the board under the clips on the USB side and then snap down on the antenna side to secure the board. This may also work for the TinyPICO and TinyS2 boards but I do not have any available. If you use this model for one of those boards please share your results in the comments. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.20mm Infill: 20% Get your Prusameters… Post your Makes! If you like this project, please don't forget to ❤ Like and ★ Rate!