About this 3D model

MY TAKE ON HIGH PERFORMANCE AIR FLOW FOR THE NEPTUNE 3 PRO/PLUS/MAX. I WOULD RECOMEND THIS FOR ANYONE USING A .6MM+ NOZZEL AND NEEDS SOME EXTRA COOLING. I WONT GO INTO THE SCIENCE FOR THIS ONE. IF YOR LOOKING INTO THIS, YOU PROBABLY ALREADY KNOW YOU NEED IT AND WHY. USES 2 5015 BLOWER FANS https://a.co/d/6iPVarf USES TWO M4x20 SCREWS FOR FANS https://a.co/d/fT4I6h2 USE THE FACTORY SHROUND MOUNTING HARDWARE OR TRY THESE ULTRA LIGHTWEIGHT TITANIUM ONES. https://a.co/d/2fGuEuL 2.0 PIN CONNECTOR FOR FANS SO YOU DONT HAVE TO CUT YOUR STOCK ONES LIKE I DID. https://a.co/d/by60ijS * *IMPORTANT NOTE ABOUT THE CONNECTORS LISTED ABOVE: RED AND BLACK ARE BACKWARDS COMPARED TO ELEGOOS WIREING! MUST SWAP RED AND WHITE TO GET FANS TO WORK WHEN USING THESE CONNECTORS START OUT AT 50% MAX FAN AT FIRST AND TUNE IT TO YOUR ENVIRONMENT. I DO RECOMEND RUNNING ANOTHER PID TUNE FOR NOZZEL TEMP AFTER INSTALL TO MAKE SURE NOT TO TRIP THE THEMAL RUNAWAY OF YOUR MACHINE FIRMWARE DUE TO THE INCREASED COOLING.