About this 3D model

This jeep was inspired by Vít Budina | Printables.com I made this so you shouldnt need supports but you may need to clean some artifacts after the print. Print recomendations: No supports. 0.4 nozzle. 0.2 layer high Print sideways If you dont use high infill be careful with the shaft , remove the print whith your bed cooled down (Just to make sure I put my bed with the print on a fridge). After the print the wheels may not move so carefully try to rotate them until they can move freely. I havent try to print in smaller/bigger but it has big tolerances so it shouldnt be a problem.