About this 3D model

This spoolholder is another take on the 3d printing nerd design challenge. This version prints faster while still having all of the features. To achive this the spool is now orineted in a 90° angle towards the spools on the shelft, whereas on my other desing the spool on the spoolholder has the same orientation as the spools on the shelf. If you have a 3/4" (18-19mm) deep board to hang this spoolholder on it might be for you. Features: Prints in one Piece, without supportsFits 30cm (11,8 inch) spoolsLoadtested up to 6 kg (13,23 lbs) (using the provided printig details)can be printed on a 20cm x 20cm (7,9" x 7,9") printbedno additional hardware needed NOTE: Check your print for underextrusion since this can significantly decrease the stability, especially when occurring on the small back part.