About this 3D model

Summary M1.6 nut driver for tightening and loosening M1.6 nuts. It's compact in size and is hollow to allow a shaft to go through the middle if needed. Great for small scale radio controlled vehicles that use M1.6 fasteners and wheel nuts. Print Settings Rafts: No Supports: No Notes: It is important to ensure your printer is dimensionally accurate when printing to ensure that a M1.6 nut will fit snug. Using a smaller size nozzle such as a 0.3mm or less is recommended. Post-Printing If a nut does not fit all the way, place it on flat and tap it with a hammer to get it to fit. You will probable need to thread the nut onto a shaft and pull to remove it. The driver will get better with use as it gets worn in.