About this 3D model

This is strictly for personal use. The photo attached is the printed model and ? FRAME ? UPDATE: A new profile has been added for people without an AMS unit. You will need to manually unload/load your filaments when the printer reaches each pause, then resume printing each time until complete. We are Venom! This is a 4 color model that is pretty straight forward to print. Like all Hueforge prints this model produces very little waste (4 poops total). You do not need to print with a brim like in my picture unless you want to. The included 3MF is set up for an AMS, but if you don't have one you can set up pauses instead of filament changes in the slicer and just manually change filaments instead. If you substitute colors based on what you have results may vary. This model is printed at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3.1 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Blue Gray At layer #19 (1.6mm) swap to Silver At layer #25 (2.08mm) swap to Jade White for the rest. Enjoy.