About this 3D model

A simple Quest 3 stand / holder with some text pattern. Features: Sun block for the back with proximity sensor cutout so it doesn't activate. Camera block in the front for privacy when you need. Who knows when the device records when you don't want it to record… Supports all positions of the face interface from low to max distance. Potentially third party interfaces as well but I could not test with others yet. With the stock Quest 3 it fits nicely. Prints as it is. No supports, brim needed. Potential little whisp strings on the front camera covers and the edges. Just use a lighter to burn them off if needed. If you use nicer filament that I have tested with it might not be needed at all. No controller holder. I might come up with something to match later. I was mostly focused in putting my Quest 3 into something other than plopping it on the top of a shelf.