About this 3D model

Simple sealed passthrough with M6/ M10 Push fittings. I highly recommend the M10 verison over the M6 one. O-Ring: 14x2,5 mm or print the sealing with a very soft filament. This Passthrough is specaial because it will allow you to insert the filament through the Passtrough without anny clogging. A problem I had with any other passthroughs I tested yet. PS: Here I have a fitting Cap for your PTFE Tubes: https://www.prusaprinters.org/prints/98167-ptfe-tube-cap-to-keep-the-filament-dry-tube-holder Update 2022: increased the tolerance for the Filament passthrough (1,8 mm -> 1,9 mm) Added a Version for M6 push fittings. Update 2024: Added a Version for 2,5 mm PTFE tubes (like Bambulab uses)