About this 3D model

FOR PRIVATE USE ONLY I create one new mini every week! Check out my Patreon for the commercial license and for a 50% Discount on my entire library. Ochre Jellies ?? I needed some Ochre Jellies for Chapter Four of the Lost Mines campaign I’m building, so I made these two. Both also have an arrow and a bone suspended inside them, small reminders that a few adventurers didn’t make it. I also included single-color versions for anyone who prefers a simpler print. Showcase video Print Details- Easy to print- Support-free design- Optimized for multicolor FDM- Matte PLA recommended to hide layer lines Includes 2x2 Ochre Jellies:- Multicolor 3MF file (for multimaterial printers & toolchangers)- Single-color STL (for resin or single-extruder FDM) Size & Print Settings100% Scale (40mm miniature): 40x34x32 mm- Recommended nozzle: 0.4mm (standard)- Recommended layer height: 0.12 mm 75% Scale (32mm miniature): 30x25x24 mm66% Scale (28mm miniature): 26x22x21 mm- Recommended nozzle: 0.2mm- Recommended layer height: 0.08 mm (or smaller) Design Note: I design my minis at 40mm scale because it’s the sweet spot for clean results on a 0.4mm nozzle while still fitting a standard 1-inch grid. If you know what you’re doing and have a smaller nozzle, you can absolutely scale them smaller. For personal use only (CC BY-NC-SA), become a Patreon for the commercial license.This product is not affiliated with, endorsed, or approved by Wizards of the Coast.