About this 3D model

This is a different take on the standard purge (poop) chute and bucket. Let your little ghosts slide or drop into the ghost trap, with handle for easy removal and dumping. 2 options available - 1 with the containment unit for those that put their ghost trap behind the printer, and 1 with a slide for those that want their ghost trap on the side. Notes: Ghost trap is meant to be assembled with glue. This was done to keep purge and print time to a minimum. Flat design meant to accommodate tight placement against printer. This has been broken out into 5 different build plates to limit each to 4 colors per plate for those with only 1 AMS. Smooth PEI recommended for the side panels and doors; just gives a nicer finish. Need to use 2 15x3 magnets for the slide. Need to use one of the longer M3 course threaded screws (or similar) from the scraper kit that came with the printer to hang the containment unit chute. Supports required for containment unit chute and part of the handle. Vent holes in side of containment unit chute to keep from impeding any airflow to the vents on back of printer. Please note the build plates are preselected. If you want to use a different build plate, please ensure you click the nut icon next to the build plate to change.