About this 3D model

Good news fellow customer; the engineers at FFFTechnology have sobered up after weeks of partying, and had designed the Wearable DSTIKE OLED Wifi Deauther MiNi Enclosure... WITH AN INTERNAL BATTERY COMPARTMENT! What a novel idea! The Wearable DSTIKE OLED Wifi Deauther MiNi Enclosure (IPS Model) has had some minor design changes including: 4mm taller in length the accommodate the battery compartment.The antenna port has been relocated to the side of the enclosure.The JST connector port has a channel designed to allow the wires to feed through.I stubbed my toe and got pissed off walking back to my desk to type this. This isn't a change, I'm now just pissed off.The top cover has been slightly redesigned to accommodate the external antenna placement.The integrated clip has a raised edge at its end to avoid sliding off clothing or straps.The FFFTech logo has is designed into casing.So what are ye waiting for you absolute mad lads? Print a Wearable DSTIKE OLED Wifi Deauther MiNi Enclosure (IPS Model), TODAY! (IPS stands for Internal Power Source.) You can find the EPS Model Here: https://www.myminifactory.com/object/3d-print-wearable-dstike-oled-wifi-deauther-mini-enclosure-111006 Post-Printing Adding Adhesive Use an electronics friendly adhesive to the inside top edge of the casing, so the enclosure cover won't slip off while wearing the device. Hardware & SoftwareHardware: DSTIKE OLED Wifi Deauther MiNi: https://maltronics.com/collections/deauthers/products/wifi-deauther-oled https://dstike.com/products/dstike-wifi-deauther-mini 400mah 3.7v LiPo Battery: https://www.adafruit.com/product/3898 The Damn Antenna: https://dstike.com/products/dstike-ipex-2dbi-wire-antenna-for-esp-07-esp32-wrover Software: https://github.com/spacehuhn/esp8266_deauther