About this 3D model

If you like my work, i'm open for donations via Paypal. It is much appreciated. https://www.paypal.com/donate/?hosted_button_id=3KZUPFUG4KLUL I'm Batman! :-) Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA Bambu PLA Black Transmission Distance: 5 PLA Bambu PLA Red Transmission Distance: 5 PLA Bambu PLA Yellow Transmission Distance: 5 PLA Bambu PLA White Matte Transmission Distance: 5 Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Red At layer #16 (1.36mm) swap to Yellow At layer #22 (1.84mm) swap to White Matte for the rest. Reminder: My models mostly cover the entire bed, this means the purge line is sometimes running through the bottom of the print. You have 3 options here: - Leave as is, you can just cut them of afterwards. - Remove immediately after the purge line is printed. - Scale the model: *** WARNING *** WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT! The Z-height must always be as original, otherwise the print is messed up.