About this 3D model

Motivation Using a p1p inside of a closed rack to: silent the printer reduce the vibrations eliminate temperature fluctuations protect the printer against draft control the temperature keep it dry filter fume protect against fire secure the power network Quickly run into the issue that the bambulab printer purge at the backside. A lot of purge! even without using the AMS. No proper way to handle the backside or use one of the 300 purge collectors that needs to have access to the printers back side. So this one with a big drawer was made. Let's get started Print with PLA or PETG, this is a very easy print you need no supports. I use a strong 20x40x5 mm magnet to fix the purge box to the printer but this is optional. There is no angle lower than 45° so you need no support for the ramp and no support for the magnet cave. It's a functional part so i printed in draft on the hot sheet with 0.4mm nozzle without glue. You may check the bed flatness with this test model upfront: flat bed / https://www.printables.com/model/303825-full-print-bed-many-printers/files You can use any sized magnet up to 40 x 20 x 5 mm best way to fix the magnet is a hot glue gun. You do not need a magnet it's just a nice to have. The small coffin 600 is made for up to 600 purges, the big one can hold more than 1200 purges. Attribution © yahbluez