About this 3D model

Adapted the X-carriage so it can house BMG extruder + motor instead of G5 Still using PP but you can attach extruder directly to BMG if you like. If you are not using PP, there is a mount point for BLTouch BLTouch X offset = 0BLTouch Y offset = -25mm Print requires support. Source: https://a360.co/361cvDj Hosted on thingiverse too: https://www.thingiverse.com/thing:4356356 INSTALLATION: attach your extruder to the precision piezo mount (e.g. part https://www.thingiverse.com/thing:3122283 or https://www.thingiverse.com/thing:3456684 or similar) attach now extruder + piezo mount to the x-carriage, rotate the extruder heatbreak fan towards the back of the assembly attach X-carriage to your MGN12H rail. First fingertighten back 2 screws (the easily accessible ones), then fingertighten the remaining 2 screws using ball end allen key. Finally slide the X-carriage back until your fan barely touches the rail and fully tighten all 4 screws - M3x8mm ideal size attach BMG + motor (M3x38mm ideal size) attach 2 blowers attach part cooling fan tips ( you can find bunch of them here: https://www.thingiverse.com/thing:4189461/files ) print :)