About this 3D model

This is a Tri rail mlok version for the AP5SD. Version 5 has a slotted middle hole on the right side rail to allow adjustment or incase you miss drilled slightly, you can also drill out the middle hole of the left side rail if needed as well. You will need to drill and tap the mounting holes using a 3.3mm drill bit and M4 tap. I used M4x10mm screw for the top hole and M4x12mm for the middle hole. If using V5 the bottom hole is to just bolt the guard to itself and I used a M4x6mm screw. I printed in ABS, if using the single piece please take care when bending it to go over the cage to not snap it.