About this 3D model

Boost Me Hey guys, I am here to introduce you EasyClip. If you have hard time to clip your filament to spool, some filament spool may not even have a clip spot. So I went online and trying to find some that will make clip filament eailer. But there are many design already out there, I just don't like them, because my fingure is not very flexible a lot of existing design I found hard to use for me, so I design this one. With little handle, it should make you life eailer. It takes very little material to print. Less than 3g. Around 11m printing time. But the prepare time takes 5 min, I suggest you to test one, and if you like it, print a patch of 10 or 20. Printing time: 5 pieces patch: 36m 14g filament. 10 pieces patch: 1h 27g filament. 15 pieces patch: 1.5h 40g filament. 20 pirces patch: 1.9h 54g filament. Enjoying, and happy printing. Instruction: make sure you drag it toward the broken end side. Also, it takes very little material to print. 2.74g.