About this 3D model

That’s SOME Clip: The Ultimate Spool Clip for 3D Printing Filament Introducing "That's SOME Clip!" , a uniquely designed 3D printable clip that ensures your filament spools remain neatly wound and tangle-free! Seamlessly integrating with the outer rim of your filament spool, this low-profile marvel prevents filament from unraveling, making it a must-have addition for master spools and re-spooled filament. ? Amazon Affiliate link to recommended CA glue Design Details: Printing Time: 6 minutes per clip (12 minutes with prep time) Layer Height: Optimal at 0.08 mm, ensuring detailed smoothness and precision. Material Compatibility: Versatile design, compatible with PLA+, PLA, PETG, ASA, ABS. Utility: Comes with a specially designed tool that aids in precise clip installation, ensuring optimum positioning and stability during the gluing process. Printing and Installation Guide: Printing: Begin by printing one installation tool and as many clips as you require. Choose a starter kit to get started. Clip Insertion: Insert the clip into the tool. Gluing: Apply a drop or two of CA glue on the inner edge of the spool. Not a lot is needed. Attachment: Use the tool to securely affix the clip onto the spool’s edge. Ensure it’s pushed all the way on for optimal placement, guided by the tool’s built-in stop. Drying: Allow adequate time for the glue to solidify and firmly hold the clip in position. Tool Removal: Remove the installation tool once the glue is completely dried. Filament Insertion: Secure the end of the filament within the clip, ensuring it stays neatly wound. Repeat: Follow the same procedure for each individual spool. Designed with meticulous attention to detail, "That’s SOME Clip" effortlessly modifies your spool, enhancing utility and printing efficiency. Embark on a clutter-free and streamlined 3D printing experience today!