About this 3D model

This is a super fun decoration to print now that the holidays are closing in. If you want a single color version , take a look at my other design I also made a ornament version I started out making a lightbox in Fusion 360, but I ended up making a tealight holder instead. You could of course use any light source you want. I would NOT recommend a burning light inside of this! (I tested it and eventually it gets too hot) Design: The best part of this model is that it can be made with “endless” combinations. Just change the colors (might be self-explanatory) OR delete files for cutout effect Standard tealight size NOTE: The better you have tuned in your first layer settings, the better this will look. The profile I have included in my model is tested thoroughly and many models got thrown away before I was satisfied. You could print this faster but I think that would compromise on quality I would recommend to have a clean bed and a clean nozzle before printing this type of model. A general rule of thumb is to print the lightest color first Some important settings I use: Layer height - 0.2mm First layer line width - 0.34 Arachne mode ON First layer flow ratio 1.02 (if your model comes out with gaps in the front, you could increase this value or calibrate your filament flow) Infill wall overlap 25% Speed: First layer – 50mm/s First layer infill – 50mm/s Outer wall – 200mm/s Inner wall – 50mm/s Infill/top – 250mm/s I would love to see what colors you use on your christmas tree!