About this 3D model

I started out making a lightbox in Fusion 360, but I ended up making a tealight holder instead. You could of course use any light source you want. I would NOT recommend a burning light inside of this! (I tested it and eventually it gets too hot) This is a more colorfull version of my model: Design: Standard tealight size NOTE: The better you have tuned in your first layer settings, the better this will look. The profile I have included in my model is tested thoroughly and many models got thrown away before I was satisfied. You could print this faster but I think that would compromise on quality I would recommend to have a clean bed and a clean nozzle before printing this type of model. Some important settings I use: Layer height - 0.2mm First layer line width - 0.34 Arachne mode ON First layer flow ratio 1.02 (if your model comes out with gaps in the front, you could increase this value or calibrate your filament flow) Infill wall overlap 25% Speed: First layer – 50mm/s First layer infill – 50mm/s Outer wall – 200mm/s Inner wall – 50mm/s Infill/top – 250mm/s