About this 3D model

Make a lot out of a little: I tried to create a piggy bank out of a simple 0.33 liter can and I think it was a success. Attention 1: The “Bottom” file contains both bodies intended for the lower area, you first have to separate them in the slicer! Attention 2: Adjust the width of x and y at the bottom part (the bigger one) by one millimeter each to ensure easy screwing on and off. Instructions: Take a narrow 0.33 liter can, cut out the inner area at the top and press the part with the money slot onto the can. Then a small part of the bottom of the can is cut off and the thread is first put over it and glued in place. The counterpart can then be screwed on and off at any time to remove money. Simply made and absolutely serves its purpose. Maximum yield with minimal filament use!